FinCoater | LSP Industries, Inc.

Stainless steel construction

Inner Guide Rolls buffer the material before entering lubricating rolls

Two rolls lubricate the material as it exits the FinCoater

Absorbent felt rolls give more versatility in the lubricant thickness applied

FinCoater - Light lubricant coating for Fin presses

The ideal roller coater to apply a very light coating of lubricant to thin gage material as it enters the fin press. Computer controlled to dispense the correct amount of lubricant to the material on each stroke of the press. Two sets of rolls, one to take the whip out of the material and one set to apply the lubricant. Shown below are all of the FinCoater features.

Simple and Precise Control

A Reservoir complete with Pump to feed lubricant to the FinCoater. The Pump is controlled by the LSP Electronic Controller. When it receives a command from the controller the pump is allowed to move the programmed amount of lubricant to the Rolls. An On/Off Valve is on the Reservoir to open and close the Rolls when a new coil has to be feed through the Fin Coater

Sizes from 13" to 49" Wide

Available with On/Off Manifolds attached to the cabinet or with Remote Manifolds, up to 10 feet away from the cabinet. For larger units the remote can be beneficial in that it eliminates walking around the coil to set the On/Off Valves. FinCoaters shown below include two Felt Inner Guide Rolls. Lubricating Rolls must be specified and ordered separately.

Lubricating Felt Rolls

The Felt Roll are absorbent giving more versatility in the lubricant thickness being applied to the stock. A small amount of lubricant can provide a light almost invisible coating to the stock. Increasing the amount of lubricant will provide a medium or heavier coating. .