PresSpray II NEW | LSP Industries, Inc.

Remove Ejectors in seconds

Non-fogging airless spray

Ejectors can be added to manifolds as needed.

Reduced lubricant consumption

PresSpray Plus - precise dispensing of fluids in an airless spray

The MicroSpray-II and the MiniSpray-II Spraying Systems deliver a predetermined amount of fluid in an Airless Spray to the work area upon command. Precise, controlled dispensing of fluids. If there is an application where a measured amount of lubricant is required on a demand schedule the LSP Airless Spray Equipment is ideally suited for the job.

How The PresSpray Plus Works.

Each nozzle is controlled by a separate Ejector. When an actuator switch is tripped either electrically or manually the Univalve air valve dumps air into an air manifold triggering all assembled ejectors. The nozzle spray patterns are individually controlled with the volume and velocity controls on each ejector.

The MicroSpray-II

Delivers a predetermined amount of fluid in an Airless Spray to the work area upon command. When an existing job needs more Ejectors simply screw another manifold into the system with four screws and then insert the new Ejector. An Ejector can be removed and replaced in minutes should service be required.

MiniSpray-II

MiniSpray-II is ideal for the larger applications or those requiring a heavier viscosity fluid. It dispenses 75 percent more fluid and can spray heavier fluids. Each Ejector allows for individual control of fluid and velocity control of the fluid. One Ejector can handle two nozzles when necessary.

Ejectors

The PresSpray-II Ejectors are used in groups of up to six units in a bank. Multiple banks can be grouped for larger applications. Each Ejector can be regulated as to the volume of fluid it is to dispense plus the velocity that the fluid is dispensed can be regulated. Dependent ejectors dispense fluid at the same time when actuated. Independent ejectors (shown above)) - either Airless or Air Assist - dispense fluid independently of each other.